Before | | 
After |
Step
1.
Part hair in a V shape from front hairline to centre nape.
| 
Step
2.
Secure top hair at crown in a band and brush one side section upwards
to just below first ponytail. Leave a small section of hair free at each side
for curling
later. |
Step
3.
Secure in a band and repeat for other side. The two side ponytails
are lower than the top one.
| 
Step
4.
Backcomb
middle ponytail and mist with hairspray.
|
Step 5.
Smooth with a bristle
brush, secure ends with section clip.
| 
Step
6.
Flip backcombed
ponytail over to front and pin with a row of grips, 2.5 cm from band. |
Step 7.
Backcomb
one side ponytail, mist with hairspray
and smooth over. | 
Step 8.
Secure end in section clip, flip to front and insert grips
as before. Repeat for other side. |
Step
9.
Shows completed side sections clipped and held forward. | 
Step
10.
Smooth one side section around hand. |
Step
11.
Roll side section round fingers smoothing into palm of hand. Twist
upwards into a cone shape. Spray
and secure with vertically placed hairpins. Coil ends into top cone.
| 
Step
12.
Twist ends in and pin. Repeat for other side, making sure cones are
symmetrical. If necessary, use ends of a tailcomb
to sleek in any wisps of hair. |
Step
13.
Take front section and re-smooth.
| 
Step
14.
Place hair centrally, blending over back coils as you sweep back and
pin. Make sure you keep an eye on the shape and balance. |
Step
15.
Smooth ends into a loose curl which covers the hairpins at back. Neaten
ends using a tailcomb.
| 
Step
16.
Tong
side hair. Re-smooth top hair if necessary and mist with hairspray
before adding a pearl and diamante tiara. |
